To figure out whether or not your wood floors are the end gone a polyurethane, shellac, wax or varnish, or have a finish that has worn away and is no longer providing coverage, the American Hardwood opinion center suggests these tests: First is govern your hand higher than the wood. If you can vibes the texture of the grain, the Flooring Contractors Kalamazoo Mi has a penetrating finish (usually a interest of a natural oil, such as linseed or tung oil, unclean gone additives for drying) topped gone wax. Second, in an out-of-the-way spot, dab upon a tiny paint remover. If the finish bubbles up, it is a surface finish, gone polyurethane, which coats the floor in a protective layer.
The third is in an out-of-the-way area, area a few drops of water. If the water beads taking place and does not soak into the wood, the finish upon the Flooring Contractors Kalamazoo Mi is intact. If the water is absorbed into the floor or leaves a dark spot, the wood is unfinished or the protective accumulation has worn away. Fourth, if you sprinkle upon a few drops of water and white spots form beneath the droplets after about 10 to 15 minutes, the floors are strong gone wax. To cut off the white spots, use a piece of fine steel wool lightly dampened gone wax and massage gently. The last is if you suspect a varnish or shellac, acknowledge a coin and cut the surface of the floor in an inconspicuous corner. If the floor has been strong gone one of the older completion methods, it will flake off.