To figure out whether or not your wood floors are the end with a polyurethane, shellac, wax or varnish, or have a finish that has worn away and is no longer providing coverage, the American Hardwood opinion middle suggests these tests: First is rule your hand higher than the wood. If you can mood the texture of the grain, the Flooring Contractors Leeds has a penetrating finish (usually a inclusion of a natural oil, such as linseed or tung oil, unclean with additives for drying) topped with wax. Second, in an out-of-the-way spot, dab on a little paint remover. If the finish bubbles up, it is a surface finish, with polyurethane, which coats the floor in a protective layer.
The third is in an out-of-the-way area, area a few drops of water. If the water beads stirring and does not soak into the wood, the finish on the Flooring Contractors Leeds is intact. If the water is absorbed into the floor or leaves a dark spot, the wood is unfinished or the protective enlargement has worn away. Fourth, if you sprinkle on a few drops of water and white spots form beneath the droplets after more or less 10 to 15 minutes, the floors are hermetic with wax. To remove the white spots, use a fragment of fine steel wool lightly dampened with wax and smear gently. The last is if you suspect a varnish or shellac, take a coin and graze the surface of the floor in an inconspicuous corner. If the floor has been hermetic with one of the older talent methods, it will flake off.