To figure out whether or not your wood floors are ended subsequently a polyurethane, shellac, wax or varnish, or have a finish that has worn away and is no longer providing coverage, the American Hardwood guidance middle suggests these tests: First is run your hand exceeding the wood. If you can feel the texture of the grain, the Flooring Contractors Ocala Florida has a penetrating finish (usually a concentration of a natural oil, such as linseed or tung oil, contaminated subsequently additives for drying) topped subsequently wax. Second, in an out-of-the-way spot, dab upon a little paint remover. If the finish bubbles up, it is a surface finish, subsequently polyurethane, which coats the floor in a protective layer.
The third is in an out-of-the-way area, place a few drops of water. If the water beads stirring and does not soak into the wood, the finish upon the Flooring Contractors Ocala Florida is intact. If the water is absorbed into the floor or leaves a dark spot, the wood is unfinished or the protective layer has worn away. Fourth, if you sprinkle upon a few drops of water and white bad skin form beneath the droplets after practically 10 to 15 minutes, the floors are unassailable subsequently wax. To sever the white spots, use a fragment of good steel wool lightly dampened subsequently wax and smear gently. The last is if you suspect a varnish or shellac, agree to a coin and graze the surface of the floor in an inconspicuous corner. If the floor has been unassailable subsequently one of the older triumph methods, it will flake off.