To figure out whether or not your wood floors are curtains later than a polyurethane, shellac, wax or varnish, or have a finish that has worn away and is no longer providing coverage, the American Hardwood guidance center suggests these tests: First is direct your hand more than the wood. If you can feel the texture of the grain, the Flooring Contractors Omaha Ne has a penetrating finish (usually a assimilation of a natural oil, such as linseed or tung oil, tainted later than additives for drying) topped later than wax. Second, in an out-of-the-way spot, dab on a little paint remover. If the finish bubbles up, it is a surface finish, later than polyurethane, which coats the floor in a protective layer.
The third is in an out-of-the-way area, area a few drops of water. If the water beads happening and does not soak into the wood, the finish on the Flooring Contractors Omaha Ne is intact. If the water is absorbed into the floor or leaves a dark spot, the wood is unfinished or the protective accumulation has worn away. Fourth, if you sprinkle on a few drops of water and white spots form beneath the droplets after nearly 10 to 15 minutes, the floors are unassailable later than wax. To surgically remove the white spots, use a piece of good steel wool lightly dampened later than wax and rub gently. The last is if you suspect a varnish or shellac, bow to a coin and scrape the surface of the floor in an inconspicuous corner. If the floor has been unassailable later than one of the older feat methods, it will flake off.