To figure out whether or not your wood floors are the end past a polyurethane, shellac, wax or varnish, or have a finish that has worn away and is no longer providing coverage, the American Hardwood suggestion center suggests these tests: First is control your hand exceeding the wood. If you can setting the texture of the grain, the Flooring Contractors Thunder Bay has a penetrating finish (usually a captivation of a natural oil, such as linseed or tung oil, impure past additives for drying) topped past wax. Second, in an out-of-the-way spot, dab upon a tiny paint remover. If the finish bubbles up, it is a surface finish, past polyurethane, which coats the floor in a protective layer.
The third is in an out-of-the-way area, area a few drops of water. If the water beads taking place and does not soak into the wood, the finish upon the Flooring Contractors Thunder Bay is intact. If the water is absorbed into the floor or leaves a dark spot, the wood is unfinished or the protective mass has worn away. Fourth, if you sprinkle upon a few drops of water and white bad skin form beneath the droplets after practically 10 to 15 minutes, the floors are unquestionable past wax. To remove the white spots, use a piece of good steel wool lightly dampened past wax and rub gently. The last is if you suspect a varnish or shellac, admit a coin and cut the surface of the floor in an inconspicuous corner. If the floor has been unquestionable past one of the older deed methods, it will flake off.