To figure out whether or not your wood floors are over and done with considering a polyurethane, shellac, wax or varnish, or have a finish that has worn away and is no longer providing coverage, the American Hardwood assistance center suggests these tests: First is direct your hand higher than the wood. If you can quality the texture of the grain, the Flooring Contractors Wilmington Nc has a penetrating finish (usually a combination of a natural oil, such as linseed or tung oil, mixed considering additives for drying) topped considering wax. Second, in an out-of-the-way spot, dab on a tiny paint remover. If the finish bubbles up, it is a surface finish, considering polyurethane, which coats the floor in a protective layer.
The third is in an out-of-the-way area, area a few drops of water. If the water beads stirring and does not soak into the wood, the finish on the Flooring Contractors Wilmington Nc is intact. If the water is absorbed into the floor or leaves a dark spot, the wood is unfinished or the protective enlargement has worn away. Fourth, if you sprinkle on a few drops of water and white a skin condition form beneath the droplets after about 10 to 15 minutes, the floors are solid considering wax. To cut off the white spots, use a piece of good steel wool lightly dampened considering wax and rub gently. The last is if you suspect a varnish or shellac, take a coin and scratch the surface of the floor in an inconspicuous corner. If the floor has been solid considering one of the older realization methods, it will flake off.