To figure out whether or not your wood floors are curtains past a polyurethane, shellac, wax or varnish, or have a finish that has worn away and is no longer providing coverage, the American Hardwood opinion middle suggests these tests: First is run your hand exceeding the wood. If you can air the texture of the grain, the Flooring Contractors Worcester has a penetrating finish (usually a interest of a natural oil, such as linseed or tung oil, tainted past additives for drying) topped past wax. Second, in an out-of-the-way spot, dab on a tiny paint remover. If the finish bubbles up, it is a surface finish, past polyurethane, which coats the floor in a protective layer.
The third is in an out-of-the-way area, place a few drops of water. If the water beads in the works and does not soak into the wood, the finish on the Flooring Contractors Worcester is intact. If the water is absorbed into the floor or leaves a dark spot, the wood is unfinished or the protective buildup has worn away. Fourth, if you sprinkle on a few drops of water and white bad skin form beneath the droplets after practically 10 to 15 minutes, the floors are sound past wax. To sever the white spots, use a piece of fine steel wool lightly dampened past wax and massage gently. The last is if you suspect a varnish or shellac, agree to a coin and scratch the surface of the floor in an inconspicuous corner. If the floor has been sound past one of the older achievement methods, it will flake off.