To figure out whether or not your wood floors are done past a polyurethane, shellac, wax or varnish, or have a finish that has worn away and is no longer providing coverage, the American Hardwood guidance middle suggests these tests: First is govern your hand more than the wood. If you can setting the texture of the grain, the Flooring That Looks Like Wood But Is Vinyl has a penetrating finish (usually a captivation of a natural oil, such as linseed or tung oil, dirty past additives for drying) topped past wax. Second, in an out-of-the-way spot, dab upon a little paint remover. If the finish bubbles up, it is a surface finish, past polyurethane, which coats the floor in a protective layer.
The third is in an out-of-the-way area, place a few drops of water. If the water beads taking place and does not soak into the wood, the finish upon the Flooring That Looks Like Wood But Is Vinyl is intact. If the water is absorbed into the floor or leaves a dark spot, the wood is unfinished or the protective accrual has worn away. Fourth, if you sprinkle upon a few drops of water and white spots form beneath the droplets after nearly 10 to 15 minutes, the floors are strong past wax. To remove the white spots, use a piece of good steel wool lightly dampened past wax and smear gently. The last is if you suspect a varnish or shellac, tolerate a coin and cut the surface of the floor in an inconspicuous corner. If the floor has been strong past one of the older feat methods, it will flake off.