To figure out whether or not your wood floors are the end considering a polyurethane, shellac, wax or varnish, or have a finish that has worn away and is no longer providing coverage, the American Hardwood information center suggests these tests: First is control your hand over the wood. If you can setting the texture of the grain, the Floors For Living Laminate has a penetrating finish (usually a engagement of a natural oil, such as linseed or tung oil, poisoned considering additives for drying) topped considering wax. Second, in an out-of-the-way spot, dab upon a little paint remover. If the finish bubbles up, it is a surface finish, considering polyurethane, which coats the floor in a protective layer.
The third is in an out-of-the-way area, place a few drops of water. If the water beads taking place and does not soak into the wood, the finish upon the Floors For Living Laminate is intact. If the water is absorbed into the floor or leaves a dark spot, the wood is unfinished or the protective mass has worn away. Fourth, if you sprinkle upon a few drops of water and white bad skin form beneath the droplets after nearly 10 to 15 minutes, the floors are sealed considering wax. To cut off the white spots, use a fragment of good steel wool lightly dampened considering wax and smooth gently. The last is if you suspect a varnish or shellac, recognize a coin and scratch the surface of the floor in an inconspicuous corner. If the floor has been sealed considering one of the older completion methods, it will flake off.