To figure out whether or not your wood floors are over and done with behind a polyurethane, shellac, wax or varnish, or have a finish that has worn away and is no longer providing coverage, the American Hardwood guidance middle suggests these tests: First is manage your hand exceeding the wood. If you can tone the texture of the grain, the Garage Floor Tiles Prices has a penetrating finish (usually a interest of a natural oil, such as linseed or tung oil, polluted behind additives for drying) topped behind wax. Second, in an out-of-the-way spot, dab upon a tiny paint remover. If the finish bubbles up, it is a surface finish, behind polyurethane, which coats the floor in a protective layer.
The third is in an out-of-the-way area, place a few drops of water. If the water beads stirring and does not soak into the wood, the finish upon the Garage Floor Tiles Prices is intact. If the water is absorbed into the floor or leaves a dark spot, the wood is unfinished or the protective layer has worn away. Fourth, if you sprinkle upon a few drops of water and white a skin condition form beneath the droplets after more or less 10 to 15 minutes, the floors are hermetically sealed behind wax. To sever the white spots, use a piece of fine steel wool lightly dampened behind wax and daub gently. The last is if you suspect a varnish or shellac, take a coin and scrape the surface of the floor in an inconspicuous corner. If the floor has been hermetically sealed behind one of the older exploit methods, it will flake off.