To figure out whether or not your wood floors are over and done with bearing in mind a polyurethane, shellac, wax or varnish, or have a finish that has worn away and is no longer providing coverage, the American Hardwood guidance middle suggests these tests: First is run your hand greater than the wood. If you can setting the texture of the grain, the Grey Vinyl Flooring That Looks Like Wood has a penetrating finish (usually a interest of a natural oil, such as linseed or tung oil, poisoned bearing in mind additives for drying) topped bearing in mind wax. Second, in an out-of-the-way spot, dab on a little paint remover. If the finish bubbles up, it is a surface finish, bearing in mind polyurethane, which coats the floor in a protective layer.
The third is in an out-of-the-way area, place a few drops of water. If the water beads happening and does not soak into the wood, the finish on the Grey Vinyl Flooring That Looks Like Wood is intact. If the water is absorbed into the floor or leaves a dark spot, the wood is unfinished or the protective deposit has worn away. Fourth, if you sprinkle on a few drops of water and white spots form beneath the droplets after very nearly 10 to 15 minutes, the floors are unassailable bearing in mind wax. To surgically remove the white spots, use a piece of good steel wool lightly dampened bearing in mind wax and rub gently. The last is if you suspect a varnish or shellac, recognize a coin and scuff the surface of the floor in an inconspicuous corner. If the floor has been unassailable bearing in mind one of the older capability methods, it will flake off.