The Best Home Improvement Ideas > Floor > Mohawk Anniston Solid Hickory Hardwood Flooring

Mohawk Anniston Solid Hickory Hardwood Flooring



Mohawk Anniston Solid Hickory Hardwood Flooring

To figure out whether or not your wood floors are finished when a polyurethane, shellac, wax or varnish, or have a finish that has worn away and is no longer providing coverage, the American Hardwood information middle suggests these tests: First is run your hand on top of the wood. If you can feel the texture of the grain, the Mohawk Anniston Solid Hickory Hardwood Flooring has a penetrating finish (usually a interest of a natural oil, such as linseed or tung oil, infected when additives for drying) topped when wax. Second, in an out-of-the-way spot, dab upon a little paint remover. If the finish bubbles up, it is a surface finish, when polyurethane, which coats the floor in a protective layer.
The third is in an out-of-the-way area, place a few drops of water. If the water beads going on and does not soak into the wood, the finish upon the Mohawk Anniston Solid Hickory Hardwood Flooring is intact. If the water is absorbed into the floor or leaves a dark spot, the wood is unfinished or the protective increase has worn away. Fourth, if you sprinkle upon a few drops of water and white bad skin form beneath the droplets after nearly 10 to 15 minutes, the floors are solid when wax. To surgically remove the white spots, use a piece of fine steel wool lightly dampened when wax and rub gently. The last is if you suspect a varnish or shellac, consent a coin and scrape the surface of the floor in an inconspicuous corner. If the floor has been solid when one of the older achievement methods, it will flake off.