To figure out whether or not your wood floors are done later than a polyurethane, shellac, wax or varnish, or have a finish that has worn away and is no longer providing coverage, the American Hardwood guidance center suggests these tests: First is rule your hand exceeding the wood. If you can setting the texture of the grain, the Mohawk Birch Hardwood Flooring has a penetrating finish (usually a raptness of a natural oil, such as linseed or tung oil, dirty later than additives for drying) topped later than wax. Second, in an out-of-the-way spot, dab on a tiny paint remover. If the finish bubbles up, it is a surface finish, later than polyurethane, which coats the floor in a protective layer.
The third is in an out-of-the-way area, area a few drops of water. If the water beads stirring and does not soak into the wood, the finish on the Mohawk Birch Hardwood Flooring is intact. If the water is absorbed into the floor or leaves a dark spot, the wood is unfinished or the protective layer has worn away. Fourth, if you sprinkle on a few drops of water and white bad skin form beneath the droplets after about 10 to 15 minutes, the floors are sound later than wax. To sever the white spots, use a fragment of good steel wool lightly dampened later than wax and massage gently. The last is if you suspect a varnish or shellac, acknowledge a coin and cut the surface of the floor in an inconspicuous corner. If the floor has been sound later than one of the older achievement methods, it will flake off.