To figure out whether or not your wood floors are over and done with as soon as a polyurethane, shellac, wax or varnish, or have a finish that has worn away and is no longer providing coverage, the American Hardwood guidance middle suggests these tests: First is manage your hand higher than the wood. If you can setting the texture of the grain, the Mohawk Brazilian Cherry Engineered Hardwood Flooring has a penetrating finish (usually a incorporation of a natural oil, such as linseed or tung oil, poisoned as soon as additives for drying) topped as soon as wax. Second, in an out-of-the-way spot, dab upon a little paint remover. If the finish bubbles up, it is a surface finish, as soon as polyurethane, which coats the floor in a protective layer.
The third is in an out-of-the-way area, area a few drops of water. If the water beads happening and does not soak into the wood, the finish upon the Mohawk Brazilian Cherry Engineered Hardwood Flooring is intact. If the water is absorbed into the floor or leaves a dark spot, the wood is unfinished or the protective buildup has worn away. Fourth, if you sprinkle upon a few drops of water and white bad skin form beneath the droplets after roughly 10 to 15 minutes, the floors are unassailable as soon as wax. To remove the white spots, use a fragment of good steel wool lightly dampened as soon as wax and rub gently. The last is if you suspect a varnish or shellac, take a coin and cut the surface of the floor in an inconspicuous corner. If the floor has been unassailable as soon as one of the older achievement methods, it will flake off.