To figure out whether or not your wood floors are done subsequently a polyurethane, shellac, wax or varnish, or have a finish that has worn away and is no longer providing coverage, the American Hardwood counsel center suggests these tests: First is govern your hand higher than the wood. If you can tone the texture of the grain, the Mohawk Floorcare Essentials Hardwood & Laminate Flooring Cleaner has a penetrating finish (usually a fascination of a natural oil, such as linseed or tung oil, dirty subsequently additives for drying) topped subsequently wax. Second, in an out-of-the-way spot, dab on a tiny paint remover. If the finish bubbles up, it is a surface finish, subsequently polyurethane, which coats the floor in a protective layer.
The third is in an out-of-the-way area, area a few drops of water. If the water beads going on and does not soak into the wood, the finish on the Mohawk Floorcare Essentials Hardwood & Laminate Flooring Cleaner is intact. If the water is absorbed into the floor or leaves a dark spot, the wood is unfinished or the protective layer has worn away. Fourth, if you sprinkle on a few drops of water and white bad skin form beneath the droplets after virtually 10 to 15 minutes, the floors are sealed subsequently wax. To sever the white spots, use a fragment of fine steel wool lightly dampened subsequently wax and massage gently. The last is if you suspect a varnish or shellac, bow to a coin and scratch the surface of the floor in an inconspicuous corner. If the floor has been sealed subsequently one of the older achievement methods, it will flake off.