To figure out whether or not your wood floors are ended later than a polyurethane, shellac, wax or varnish, or have a finish that has worn away and is no longer providing coverage, the American Hardwood assistance middle suggests these tests: First is govern your hand higher than the wood. If you can atmosphere the texture of the grain, the Mohawk Hardwood Flooring Acacia Forest has a penetrating finish (usually a amalgamation of a natural oil, such as linseed or tung oil, tainted later than additives for drying) topped later than wax. Second, in an out-of-the-way spot, dab upon a tiny paint remover. If the finish bubbles up, it is a surface finish, later than polyurethane, which coats the floor in a protective layer.
The third is in an out-of-the-way area, place a few drops of water. If the water beads going on and does not soak into the wood, the finish upon the Mohawk Hardwood Flooring Acacia Forest is intact. If the water is absorbed into the floor or leaves a dark spot, the wood is unfinished or the protective buildup has worn away. Fourth, if you sprinkle upon a few drops of water and white spots form beneath the droplets after very nearly 10 to 15 minutes, the floors are strong later than wax. To surgically remove the white spots, use a piece of good steel wool lightly dampened later than wax and smear gently. The last is if you suspect a varnish or shellac, give a positive response a coin and cut the surface of the floor in an inconspicuous corner. If the floor has been strong later than one of the older exploit methods, it will flake off.