To figure out whether or not your wood floors are over and done with like a polyurethane, shellac, wax or varnish, or have a finish that has worn away and is no longer providing coverage, the American Hardwood guidance middle suggests these tests: First is run your hand beyond the wood. If you can tone the texture of the grain, the Mohawk Hardwood Flooring Artiquity Collection has a penetrating finish (usually a raptness of a natural oil, such as linseed or tung oil, tainted like additives for drying) topped like wax. Second, in an out-of-the-way spot, dab on a little paint remover. If the finish bubbles up, it is a surface finish, like polyurethane, which coats the floor in a protective layer.
The third is in an out-of-the-way area, place a few drops of water. If the water beads happening and does not soak into the wood, the finish on the Mohawk Hardwood Flooring Artiquity Collection is intact. If the water is absorbed into the floor or leaves a dark spot, the wood is unfinished or the protective growth has worn away. Fourth, if you sprinkle on a few drops of water and white bad skin form beneath the droplets after about 10 to 15 minutes, the floors are hermetically sealed like wax. To surgically remove the white spots, use a fragment of good steel wool lightly dampened like wax and smooth gently. The last is if you suspect a varnish or shellac, agree to a coin and graze the surface of the floor in an inconspicuous corner. If the floor has been hermetically sealed like one of the older endowment methods, it will flake off.