To figure out whether or not your wood floors are the end with a polyurethane, shellac, wax or varnish, or have a finish that has worn away and is no longer providing coverage, the American Hardwood recommendation middle suggests these tests: First is control your hand on top of the wood. If you can tone the texture of the grain, the Mohawk Hardwood Flooring Cleaner has a penetrating finish (usually a inclusion of a natural oil, such as linseed or tung oil, contaminated with additives for drying) topped with wax. Second, in an out-of-the-way spot, dab upon a tiny paint remover. If the finish bubbles up, it is a surface finish, with polyurethane, which coats the floor in a protective layer.
The third is in an out-of-the-way area, place a few drops of water. If the water beads in the works and does not soak into the wood, the finish upon the Mohawk Hardwood Flooring Cleaner is intact. If the water is absorbed into the floor or leaves a dark spot, the wood is unfinished or the protective increase has worn away. Fourth, if you sprinkle upon a few drops of water and white a skin condition form beneath the droplets after just about 10 to 15 minutes, the floors are hermetic with wax. To cut off the white spots, use a piece of fine steel wool lightly dampened with wax and smooth gently. The last is if you suspect a varnish or shellac, assume a coin and scrape the surface of the floor in an inconspicuous corner. If the floor has been hermetic with one of the older triumph methods, it will flake off.