To figure out whether or not your wood floors are done with a polyurethane, shellac, wax or varnish, or have a finish that has worn away and is no longer providing coverage, the American Hardwood guidance center suggests these tests: First is control your hand greater than the wood. If you can feel the texture of the grain, the Mohawk Hardwood Flooring Colors has a penetrating finish (usually a amalgamation of a natural oil, such as linseed or tung oil, polluted with additives for drying) topped with wax. Second, in an out-of-the-way spot, dab on a tiny paint remover. If the finish bubbles up, it is a surface finish, with polyurethane, which coats the floor in a protective layer.
The third is in an out-of-the-way area, area a few drops of water. If the water beads happening and does not soak into the wood, the finish on the Mohawk Hardwood Flooring Colors is intact. If the water is absorbed into the floor or leaves a dark spot, the wood is unfinished or the protective mass has worn away. Fourth, if you sprinkle on a few drops of water and white a skin condition form beneath the droplets after approximately 10 to 15 minutes, the floors are unquestionable with wax. To cut off the white spots, use a fragment of fine steel wool lightly dampened with wax and daub gently. The last is if you suspect a varnish or shellac, understand a coin and scratch the surface of the floor in an inconspicuous corner. If the floor has been unquestionable with one of the older execution methods, it will flake off.