To figure out whether or not your wood floors are done following a polyurethane, shellac, wax or varnish, or have a finish that has worn away and is no longer providing coverage, the American Hardwood instruction middle suggests these tests: First is govern your hand more than the wood. If you can tone the texture of the grain, the Mohawk Hardwood Flooring Customer Reviews has a penetrating finish (usually a incorporation of a natural oil, such as linseed or tung oil, impure following additives for drying) topped following wax. Second, in an out-of-the-way spot, dab upon a little paint remover. If the finish bubbles up, it is a surface finish, following polyurethane, which coats the floor in a protective layer.
The third is in an out-of-the-way area, place a few drops of water. If the water beads happening and does not soak into the wood, the finish upon the Mohawk Hardwood Flooring Customer Reviews is intact. If the water is absorbed into the floor or leaves a dark spot, the wood is unfinished or the protective layer has worn away. Fourth, if you sprinkle upon a few drops of water and white a skin condition form beneath the droplets after not quite 10 to 15 minutes, the floors are solid following wax. To cut off the white spots, use a piece of fine steel wool lightly dampened following wax and massage gently. The last is if you suspect a varnish or shellac, bow to a coin and scrape the surface of the floor in an inconspicuous corner. If the floor has been solid following one of the older completion methods, it will flake off.