To figure out whether or not your wood floors are the end in the manner of a polyurethane, shellac, wax or varnish, or have a finish that has worn away and is no longer providing coverage, the American Hardwood guidance middle suggests these tests: First is control your hand greater than the wood. If you can tone the texture of the grain, the Mohawk Hardwood Flooring Golden Oak has a penetrating finish (usually a immersion of a natural oil, such as linseed or tung oil, unclean in the manner of additives for drying) topped in the manner of wax. Second, in an out-of-the-way spot, dab on a tiny paint remover. If the finish bubbles up, it is a surface finish, in the manner of polyurethane, which coats the floor in a protective layer.
The third is in an out-of-the-way area, area a few drops of water. If the water beads stirring and does not soak into the wood, the finish on the Mohawk Hardwood Flooring Golden Oak is intact. If the water is absorbed into the floor or leaves a dark spot, the wood is unfinished or the protective addition has worn away. Fourth, if you sprinkle on a few drops of water and white bad skin form beneath the droplets after practically 10 to 15 minutes, the floors are sealed in the manner of wax. To remove the white spots, use a fragment of fine steel wool lightly dampened in the manner of wax and smooth gently. The last is if you suspect a varnish or shellac, bow to a coin and cut the surface of the floor in an inconspicuous corner. If the floor has been sealed in the manner of one of the older attainment methods, it will flake off.