To figure out whether or not your wood floors are the end bearing in mind a polyurethane, shellac, wax or varnish, or have a finish that has worn away and is no longer providing coverage, the American Hardwood opinion center suggests these tests: First is manage your hand higher than the wood. If you can setting the texture of the grain, the Mohawk Hardwood Flooring Hickory Country Natural has a penetrating finish (usually a immersion of a natural oil, such as linseed or tung oil, contaminated bearing in mind additives for drying) topped bearing in mind wax. Second, in an out-of-the-way spot, dab on a little paint remover. If the finish bubbles up, it is a surface finish, bearing in mind polyurethane, which coats the floor in a protective layer.
The third is in an out-of-the-way area, place a few drops of water. If the water beads happening and does not soak into the wood, the finish on the Mohawk Hardwood Flooring Hickory Country Natural is intact. If the water is absorbed into the floor or leaves a dark spot, the wood is unfinished or the protective addition has worn away. Fourth, if you sprinkle on a few drops of water and white a skin condition form beneath the droplets after approximately 10 to 15 minutes, the floors are hermetically sealed bearing in mind wax. To cut off the white spots, use a fragment of fine steel wool lightly dampened bearing in mind wax and massage gently. The last is if you suspect a varnish or shellac, say yes a coin and graze the surface of the floor in an inconspicuous corner. If the floor has been hermetically sealed bearing in mind one of the older achievement methods, it will flake off.