To figure out whether or not your wood floors are over and done with next a polyurethane, shellac, wax or varnish, or have a finish that has worn away and is no longer providing coverage, the American Hardwood information middle suggests these tests: First is direct your hand higher than the wood. If you can atmosphere the texture of the grain, the Mohawk Hardwood Flooring Maple Sienna has a penetrating finish (usually a captivation of a natural oil, such as linseed or tung oil, unclean next additives for drying) topped next wax. Second, in an out-of-the-way spot, dab upon a tiny paint remover. If the finish bubbles up, it is a surface finish, next polyurethane, which coats the floor in a protective layer.
The third is in an out-of-the-way area, area a few drops of water. If the water beads taking place and does not soak into the wood, the finish upon the Mohawk Hardwood Flooring Maple Sienna is intact. If the water is absorbed into the floor or leaves a dark spot, the wood is unfinished or the protective increase has worn away. Fourth, if you sprinkle upon a few drops of water and white bad skin form beneath the droplets after just about 10 to 15 minutes, the floors are hermetically sealed next wax. To sever the white spots, use a fragment of fine steel wool lightly dampened next wax and smear gently. The last is if you suspect a varnish or shellac, put up with a coin and scuff the surface of the floor in an inconspicuous corner. If the floor has been hermetically sealed next one of the older feat methods, it will flake off.