To figure out whether or not your wood floors are over and done with once a polyurethane, shellac, wax or varnish, or have a finish that has worn away and is no longer providing coverage, the American Hardwood guidance middle suggests these tests: First is rule your hand over the wood. If you can vibes the texture of the grain, the Mohawk Hardwood Flooring Oak Shale has a penetrating finish (usually a concentration of a natural oil, such as linseed or tung oil, dirty once additives for drying) topped once wax. Second, in an out-of-the-way spot, dab on a tiny paint remover. If the finish bubbles up, it is a surface finish, once polyurethane, which coats the floor in a protective layer.
The third is in an out-of-the-way area, place a few drops of water. If the water beads occurring and does not soak into the wood, the finish on the Mohawk Hardwood Flooring Oak Shale is intact. If the water is absorbed into the floor or leaves a dark spot, the wood is unfinished or the protective lump has worn away. Fourth, if you sprinkle on a few drops of water and white bad skin form beneath the droplets after just about 10 to 15 minutes, the floors are sound once wax. To remove the white spots, use a fragment of good steel wool lightly dampened once wax and smear gently. The last is if you suspect a varnish or shellac, admit a coin and scratch the surface of the floor in an inconspicuous corner. If the floor has been sound once one of the older capability methods, it will flake off.