To figure out whether or not your wood floors are finished behind a polyurethane, shellac, wax or varnish, or have a finish that has worn away and is no longer providing coverage, the American Hardwood recommendation middle suggests these tests: First is control your hand on top of the wood. If you can environment the texture of the grain, the Mohawk Hardwood Flooring Samples has a penetrating finish (usually a engagement of a natural oil, such as linseed or tung oil, polluted behind additives for drying) topped behind wax. Second, in an out-of-the-way spot, dab on a tiny paint remover. If the finish bubbles up, it is a surface finish, behind polyurethane, which coats the floor in a protective layer.
The third is in an out-of-the-way area, area a few drops of water. If the water beads happening and does not soak into the wood, the finish on the Mohawk Hardwood Flooring Samples is intact. If the water is absorbed into the floor or leaves a dark spot, the wood is unfinished or the protective accrual has worn away. Fourth, if you sprinkle on a few drops of water and white a skin condition form beneath the droplets after more or less 10 to 15 minutes, the floors are hermetically sealed behind wax. To separate the white spots, use a fragment of fine steel wool lightly dampened behind wax and daub gently. The last is if you suspect a varnish or shellac, tolerate a coin and scrape the surface of the floor in an inconspicuous corner. If the floor has been hermetically sealed behind one of the older achievement methods, it will flake off.