The Best Home Improvement Ideas > Floor > Mohawk Hardwood Flooring With Scotchgard

Mohawk Hardwood Flooring With Scotchgard



Mohawk Hardwood Flooring With Scotchgard

To figure out whether or not your wood floors are finished like a polyurethane, shellac, wax or varnish, or have a finish that has worn away and is no longer providing coverage, the American Hardwood instruction middle suggests these tests: First is control your hand higher than the wood. If you can feel the texture of the grain, the Mohawk Hardwood Flooring With Scotchgard has a penetrating finish (usually a amalgamation of a natural oil, such as linseed or tung oil, impure like additives for drying) topped like wax. Second, in an out-of-the-way spot, dab on a little paint remover. If the finish bubbles up, it is a surface finish, like polyurethane, which coats the floor in a protective layer.
The third is in an out-of-the-way area, area a few drops of water. If the water beads happening and does not soak into the wood, the finish on the Mohawk Hardwood Flooring With Scotchgard is intact. If the water is absorbed into the floor or leaves a dark spot, the wood is unfinished or the protective accumulation has worn away. Fourth, if you sprinkle on a few drops of water and white spots form beneath the droplets after very nearly 10 to 15 minutes, the floors are unquestionable like wax. To remove the white spots, use a fragment of good steel wool lightly dampened like wax and rub gently. The last is if you suspect a varnish or shellac, assume a coin and scratch the surface of the floor in an inconspicuous corner. If the floor has been unquestionable like one of the older deed methods, it will flake off.