To figure out whether or not your wood floors are done afterward a polyurethane, shellac, wax or varnish, or have a finish that has worn away and is no longer providing coverage, the American Hardwood suggestion center suggests these tests: First is govern your hand over the wood. If you can tone the texture of the grain, the Mohawk Hardwood Floors Michigan has a penetrating finish (usually a raptness of a natural oil, such as linseed or tung oil, polluted afterward additives for drying) topped afterward wax. Second, in an out-of-the-way spot, dab upon a little paint remover. If the finish bubbles up, it is a surface finish, afterward polyurethane, which coats the floor in a protective layer.
The third is in an out-of-the-way area, area a few drops of water. If the water beads happening and does not soak into the wood, the finish upon the Mohawk Hardwood Floors Michigan is intact. If the water is absorbed into the floor or leaves a dark spot, the wood is unfinished or the protective bump has worn away. Fourth, if you sprinkle upon a few drops of water and white bad skin form beneath the droplets after more or less 10 to 15 minutes, the floors are unassailable afterward wax. To surgically remove the white spots, use a fragment of good steel wool lightly dampened afterward wax and rub gently. The last is if you suspect a varnish or shellac, give a positive response a coin and scrape the surface of the floor in an inconspicuous corner. If the floor has been unassailable afterward one of the older attainment methods, it will flake off.