To figure out whether or not your wood floors are the end subsequent to a polyurethane, shellac, wax or varnish, or have a finish that has worn away and is no longer providing coverage, the American Hardwood guidance middle suggests these tests: First is manage your hand higher than the wood. If you can setting the texture of the grain, the Mohawk Hardwood Floors Taylor Mi has a penetrating finish (usually a engagement of a natural oil, such as linseed or tung oil, mixed subsequent to additives for drying) topped subsequent to wax. Second, in an out-of-the-way spot, dab on a little paint remover. If the finish bubbles up, it is a surface finish, subsequent to polyurethane, which coats the floor in a protective layer.
The third is in an out-of-the-way area, place a few drops of water. If the water beads happening and does not soak into the wood, the finish on the Mohawk Hardwood Floors Taylor Mi is intact. If the water is absorbed into the floor or leaves a dark spot, the wood is unfinished or the protective deposit has worn away. Fourth, if you sprinkle on a few drops of water and white bad skin form beneath the droplets after just about 10 to 15 minutes, the floors are hermetic subsequent to wax. To remove the white spots, use a fragment of good steel wool lightly dampened subsequent to wax and rub gently. The last is if you suspect a varnish or shellac, acknowledge a coin and scuff the surface of the floor in an inconspicuous corner. If the floor has been hermetic subsequent to one of the older finishing methods, it will flake off.