To figure out whether or not your wood floors are done subsequent to a polyurethane, shellac, wax or varnish, or have a finish that has worn away and is no longer providing coverage, the American Hardwood information center suggests these tests: First is manage your hand exceeding the wood. If you can setting the texture of the grain, the Mohawk Oxford Engineered Oak Hardwood Flooring has a penetrating finish (usually a inclusion of a natural oil, such as linseed or tung oil, infected subsequent to additives for drying) topped subsequent to wax. Second, in an out-of-the-way spot, dab on a tiny paint remover. If the finish bubbles up, it is a surface finish, subsequent to polyurethane, which coats the floor in a protective layer.
The third is in an out-of-the-way area, place a few drops of water. If the water beads occurring and does not soak into the wood, the finish on the Mohawk Oxford Engineered Oak Hardwood Flooring is intact. If the water is absorbed into the floor or leaves a dark spot, the wood is unfinished or the protective deposit has worn away. Fourth, if you sprinkle on a few drops of water and white a skin condition form beneath the droplets after very nearly 10 to 15 minutes, the floors are hermetic subsequent to wax. To sever the white spots, use a piece of good steel wool lightly dampened subsequent to wax and massage gently. The last is if you suspect a varnish or shellac, take a coin and scratch the surface of the floor in an inconspicuous corner. If the floor has been hermetic subsequent to one of the older realization methods, it will flake off.