To figure out whether or not your wood floors are finished gone a polyurethane, shellac, wax or varnish, or have a finish that has worn away and is no longer providing coverage, the American Hardwood suggestion center suggests these tests: First is direct your hand exceeding the wood. If you can character the texture of the grain, the Mohawk Woodbourne Hardwood Flooring has a penetrating finish (usually a captivation of a natural oil, such as linseed or tung oil, contaminated gone additives for drying) topped gone wax. Second, in an out-of-the-way spot, dab on a tiny paint remover. If the finish bubbles up, it is a surface finish, gone polyurethane, which coats the floor in a protective layer.
The third is in an out-of-the-way area, place a few drops of water. If the water beads stirring and does not soak into the wood, the finish on the Mohawk Woodbourne Hardwood Flooring is intact. If the water is absorbed into the floor or leaves a dark spot, the wood is unfinished or the protective enlargement has worn away. Fourth, if you sprinkle on a few drops of water and white a skin condition form beneath the droplets after nearly 10 to 15 minutes, the floors are sealed gone wax. To remove the white spots, use a fragment of good steel wool lightly dampened gone wax and smear gently. The last is if you suspect a varnish or shellac, say yes a coin and scrape the surface of the floor in an inconspicuous corner. If the floor has been sealed gone one of the older endowment methods, it will flake off.