To figure out whether or not your wood floors are finished in the same way as a polyurethane, shellac, wax or varnish, or have a finish that has worn away and is no longer providing coverage, the American Hardwood opinion middle suggests these tests: First is direct your hand higher than the wood. If you can tone the texture of the grain, the Porcelain Garage Floor Tiles Uk has a penetrating finish (usually a incorporation of a natural oil, such as linseed or tung oil, tainted in the same way as additives for drying) topped in the same way as wax. Second, in an out-of-the-way spot, dab upon a tiny paint remover. If the finish bubbles up, it is a surface finish, in the same way as polyurethane, which coats the floor in a protective layer.
The third is in an out-of-the-way area, place a few drops of water. If the water beads occurring and does not soak into the wood, the finish upon the Porcelain Garage Floor Tiles Uk is intact. If the water is absorbed into the floor or leaves a dark spot, the wood is unfinished or the protective mass has worn away. Fourth, if you sprinkle upon a few drops of water and white spots form beneath the droplets after more or less 10 to 15 minutes, the floors are strong in the same way as wax. To separate the white spots, use a fragment of good steel wool lightly dampened in the same way as wax and daub gently. The last is if you suspect a varnish or shellac, agree to a coin and cut the surface of the floor in an inconspicuous corner. If the floor has been strong in the same way as one of the older deed methods, it will flake off.