To figure out whether or not your wood floors are ended in imitation of a polyurethane, shellac, wax or varnish, or have a finish that has worn away and is no longer providing coverage, the American Hardwood guidance middle suggests these tests: First is control your hand over the wood. If you can mood the texture of the grain, the Quality Flooring Company Houston has a penetrating finish (usually a interest of a natural oil, such as linseed or tung oil, unclean in imitation of additives for drying) topped in imitation of wax. Second, in an out-of-the-way spot, dab upon a tiny paint remover. If the finish bubbles up, it is a surface finish, in imitation of polyurethane, which coats the floor in a protective layer.
The third is in an out-of-the-way area, place a few drops of water. If the water beads in the works and does not soak into the wood, the finish upon the Quality Flooring Company Houston is intact. If the water is absorbed into the floor or leaves a dark spot, the wood is unfinished or the protective layer has worn away. Fourth, if you sprinkle upon a few drops of water and white spots form beneath the droplets after practically 10 to 15 minutes, the floors are unassailable in imitation of wax. To remove the white spots, use a fragment of good steel wool lightly dampened in imitation of wax and rub gently. The last is if you suspect a varnish or shellac, recognize a coin and scuff the surface of the floor in an inconspicuous corner. If the floor has been unassailable in imitation of one of the older carrying out methods, it will flake off.