To figure out whether or not your wood floors are done in the manner of a polyurethane, shellac, wax or varnish, or have a finish that has worn away and is no longer providing coverage, the American Hardwood information center suggests these tests: First is govern your hand over the wood. If you can mood the texture of the grain, the Quick Step Flooring Adelaide has a penetrating finish (usually a fascination of a natural oil, such as linseed or tung oil, contaminated in the manner of additives for drying) topped in the manner of wax. Second, in an out-of-the-way spot, dab on a little paint remover. If the finish bubbles up, it is a surface finish, in the manner of polyurethane, which coats the floor in a protective layer.
The third is in an out-of-the-way area, area a few drops of water. If the water beads in the works and does not soak into the wood, the finish on the Quick Step Flooring Adelaide is intact. If the water is absorbed into the floor or leaves a dark spot, the wood is unfinished or the protective mass has worn away. Fourth, if you sprinkle on a few drops of water and white a skin condition form beneath the droplets after more or less 10 to 15 minutes, the floors are sound in the manner of wax. To cut off the white spots, use a fragment of good steel wool lightly dampened in the manner of wax and daub gently. The last is if you suspect a varnish or shellac, recognize a coin and scuff the surface of the floor in an inconspicuous corner. If the floor has been sound in the manner of one of the older carrying out methods, it will flake off.