To figure out whether or not your wood floors are finished gone a polyurethane, shellac, wax or varnish, or have a finish that has worn away and is no longer providing coverage, the American Hardwood counsel center suggests these tests: First is manage your hand higher than the wood. If you can vibes the texture of the grain, the Quick Step Flooring B&q has a penetrating finish (usually a immersion of a natural oil, such as linseed or tung oil, mixed gone additives for drying) topped gone wax. Second, in an out-of-the-way spot, dab on a tiny paint remover. If the finish bubbles up, it is a surface finish, gone polyurethane, which coats the floor in a protective layer.
The third is in an out-of-the-way area, place a few drops of water. If the water beads up and does not soak into the wood, the finish on the Quick Step Flooring B&q is intact. If the water is absorbed into the floor or leaves a dark spot, the wood is unfinished or the protective accrual has worn away. Fourth, if you sprinkle on a few drops of water and white bad skin form beneath the droplets after more or less 10 to 15 minutes, the floors are hermetic gone wax. To cut off the white spots, use a piece of fine steel wool lightly dampened gone wax and smooth gently. The last is if you suspect a varnish or shellac, acknowledge a coin and graze the surface of the floor in an inconspicuous corner. If the floor has been hermetic gone one of the older success methods, it will flake off.