To figure out whether or not your wood floors are over and done with afterward a polyurethane, shellac, wax or varnish, or have a finish that has worn away and is no longer providing coverage, the American Hardwood guidance middle suggests these tests: First is rule your hand more than the wood. If you can feel the texture of the grain, the Quick Step Flooring Essex has a penetrating finish (usually a interest of a natural oil, such as linseed or tung oil, impure afterward additives for drying) topped afterward wax. Second, in an out-of-the-way spot, dab upon a little paint remover. If the finish bubbles up, it is a surface finish, afterward polyurethane, which coats the floor in a protective layer.
The third is in an out-of-the-way area, area a few drops of water. If the water beads in the works and does not soak into the wood, the finish upon the Quick Step Flooring Essex is intact. If the water is absorbed into the floor or leaves a dark spot, the wood is unfinished or the protective layer has worn away. Fourth, if you sprinkle upon a few drops of water and white spots form beneath the droplets after very nearly 10 to 15 minutes, the floors are unquestionable afterward wax. To cut off the white spots, use a piece of good steel wool lightly dampened afterward wax and massage gently. The last is if you suspect a varnish or shellac, put up with a coin and cut the surface of the floor in an inconspicuous corner. If the floor has been unquestionable afterward one of the older achievement methods, it will flake off.