To figure out whether or not your wood floors are over and done with behind a polyurethane, shellac, wax or varnish, or have a finish that has worn away and is no longer providing coverage, the American Hardwood guidance center suggests these tests: First is govern your hand beyond the wood. If you can feel the texture of the grain, the Quick Step Flooring Liverpool has a penetrating finish (usually a concentration of a natural oil, such as linseed or tung oil, dirty behind additives for drying) topped behind wax. Second, in an out-of-the-way spot, dab upon a little paint remover. If the finish bubbles up, it is a surface finish, behind polyurethane, which coats the floor in a protective layer.
The third is in an out-of-the-way area, place a few drops of water. If the water beads going on and does not soak into the wood, the finish upon the Quick Step Flooring Liverpool is intact. If the water is absorbed into the floor or leaves a dark spot, the wood is unfinished or the protective accumulation has worn away. Fourth, if you sprinkle upon a few drops of water and white bad skin form beneath the droplets after nearly 10 to 15 minutes, the floors are unassailable behind wax. To surgically remove the white spots, use a fragment of good steel wool lightly dampened behind wax and rub gently. The last is if you suspect a varnish or shellac, endure a coin and scrape the surface of the floor in an inconspicuous corner. If the floor has been unassailable behind one of the older deed methods, it will flake off.