To figure out whether or not your wood floors are done later a polyurethane, shellac, wax or varnish, or have a finish that has worn away and is no longer providing coverage, the American Hardwood recommendation center suggests these tests: First is run your hand beyond the wood. If you can vibes the texture of the grain, the Quick Step Flooring Majestic has a penetrating finish (usually a interest of a natural oil, such as linseed or tung oil, polluted later additives for drying) topped later wax. Second, in an out-of-the-way spot, dab on a little paint remover. If the finish bubbles up, it is a surface finish, later polyurethane, which coats the floor in a protective layer.
The third is in an out-of-the-way area, place a few drops of water. If the water beads going on and does not soak into the wood, the finish on the Quick Step Flooring Majestic is intact. If the water is absorbed into the floor or leaves a dark spot, the wood is unfinished or the protective buildup has worn away. Fourth, if you sprinkle on a few drops of water and white spots form beneath the droplets after very nearly 10 to 15 minutes, the floors are strong later wax. To surgically remove the white spots, use a fragment of fine steel wool lightly dampened later wax and daub gently. The last is if you suspect a varnish or shellac, say you will a coin and graze the surface of the floor in an inconspicuous corner. If the floor has been strong later one of the older capability methods, it will flake off.