To figure out whether or not your wood floors are finished subsequently a polyurethane, shellac, wax or varnish, or have a finish that has worn away and is no longer providing coverage, the American Hardwood opinion middle suggests these tests: First is rule your hand higher than the wood. If you can vibes the texture of the grain, the Quick Step Flooring Oldham has a penetrating finish (usually a raptness of a natural oil, such as linseed or tung oil, infected subsequently additives for drying) topped subsequently wax. Second, in an out-of-the-way spot, dab on a tiny paint remover. If the finish bubbles up, it is a surface finish, subsequently polyurethane, which coats the floor in a protective layer.
The third is in an out-of-the-way area, place a few drops of water. If the water beads stirring and does not soak into the wood, the finish on the Quick Step Flooring Oldham is intact. If the water is absorbed into the floor or leaves a dark spot, the wood is unfinished or the protective layer has worn away. Fourth, if you sprinkle on a few drops of water and white bad skin form beneath the droplets after practically 10 to 15 minutes, the floors are unassailable subsequently wax. To separate the white spots, use a fragment of good steel wool lightly dampened subsequently wax and rub gently. The last is if you suspect a varnish or shellac, bow to a coin and scratch the surface of the floor in an inconspicuous corner. If the floor has been unassailable subsequently one of the older capability methods, it will flake off.