To figure out whether or not your wood floors are the end considering a polyurethane, shellac, wax or varnish, or have a finish that has worn away and is no longer providing coverage, the American Hardwood assistance middle suggests these tests: First is manage your hand exceeding the wood. If you can atmosphere the texture of the grain, the Quick Step Flooring Quality has a penetrating finish (usually a captivation of a natural oil, such as linseed or tung oil, unclean considering additives for drying) topped considering wax. Second, in an out-of-the-way spot, dab on a little paint remover. If the finish bubbles up, it is a surface finish, considering polyurethane, which coats the floor in a protective layer.
The third is in an out-of-the-way area, area a few drops of water. If the water beads up and does not soak into the wood, the finish on the Quick Step Flooring Quality is intact. If the water is absorbed into the floor or leaves a dark spot, the wood is unfinished or the protective buildup has worn away. Fourth, if you sprinkle on a few drops of water and white a skin condition form beneath the droplets after virtually 10 to 15 minutes, the floors are hermetic considering wax. To separate the white spots, use a piece of good steel wool lightly dampened considering wax and rub gently. The last is if you suspect a varnish or shellac, admit a coin and scratch the surface of the floor in an inconspicuous corner. If the floor has been hermetic considering one of the older capability methods, it will flake off.