To figure out whether or not your wood floors are the end next a polyurethane, shellac, wax or varnish, or have a finish that has worn away and is no longer providing coverage, the American Hardwood guidance center suggests these tests: First is rule your hand more than the wood. If you can quality the texture of the grain, the Quick Step Flooring Swansea has a penetrating finish (usually a engagement of a natural oil, such as linseed or tung oil, infected next additives for drying) topped next wax. Second, in an out-of-the-way spot, dab on a little paint remover. If the finish bubbles up, it is a surface finish, next polyurethane, which coats the floor in a protective layer.
The third is in an out-of-the-way area, area a few drops of water. If the water beads happening and does not soak into the wood, the finish on the Quick Step Flooring Swansea is intact. If the water is absorbed into the floor or leaves a dark spot, the wood is unfinished or the protective enlargement has worn away. Fourth, if you sprinkle on a few drops of water and white spots form beneath the droplets after approximately 10 to 15 minutes, the floors are hermetic next wax. To remove the white spots, use a fragment of fine steel wool lightly dampened next wax and rub gently. The last is if you suspect a varnish or shellac, say you will a coin and cut the surface of the floor in an inconspicuous corner. If the floor has been hermetic next one of the older completion methods, it will flake off.