To figure out whether or not your wood floors are over and done with as soon as a polyurethane, shellac, wax or varnish, or have a finish that has worn away and is no longer providing coverage, the American Hardwood information center suggests these tests: First is control your hand exceeding the wood. If you can character the texture of the grain, the Quick Step Flooring U896 has a penetrating finish (usually a fascination of a natural oil, such as linseed or tung oil, impure as soon as additives for drying) topped as soon as wax. Second, in an out-of-the-way spot, dab on a tiny paint remover. If the finish bubbles up, it is a surface finish, as soon as polyurethane, which coats the floor in a protective layer.
The third is in an out-of-the-way area, area a few drops of water. If the water beads going on and does not soak into the wood, the finish on the Quick Step Flooring U896 is intact. If the water is absorbed into the floor or leaves a dark spot, the wood is unfinished or the protective growth has worn away. Fourth, if you sprinkle on a few drops of water and white bad skin form beneath the droplets after nearly 10 to 15 minutes, the floors are unassailable as soon as wax. To sever the white spots, use a fragment of good steel wool lightly dampened as soon as wax and rub gently. The last is if you suspect a varnish or shellac, take a coin and scuff the surface of the floor in an inconspicuous corner. If the floor has been unassailable as soon as one of the older realization methods, it will flake off.