To figure out whether or not your wood floors are done behind a polyurethane, shellac, wax or varnish, or have a finish that has worn away and is no longer providing coverage, the American Hardwood guidance middle suggests these tests: First is manage your hand more than the wood. If you can mood the texture of the grain, the Quick Step Flooring Uniclic has a penetrating finish (usually a combination of a natural oil, such as linseed or tung oil, impure behind additives for drying) topped behind wax. Second, in an out-of-the-way spot, dab upon a little paint remover. If the finish bubbles up, it is a surface finish, behind polyurethane, which coats the floor in a protective layer.
The third is in an out-of-the-way area, place a few drops of water. If the water beads going on and does not soak into the wood, the finish upon the Quick Step Flooring Uniclic is intact. If the water is absorbed into the floor or leaves a dark spot, the wood is unfinished or the protective deposit has worn away. Fourth, if you sprinkle upon a few drops of water and white a skin condition form beneath the droplets after more or less 10 to 15 minutes, the floors are strong behind wax. To cut off the white spots, use a fragment of good steel wool lightly dampened behind wax and massage gently. The last is if you suspect a varnish or shellac, assume a coin and cut the surface of the floor in an inconspicuous corner. If the floor has been strong behind one of the older triumph methods, it will flake off.