To figure out whether or not your wood floors are done like a polyurethane, shellac, wax or varnish, or have a finish that has worn away and is no longer providing coverage, the American Hardwood recommendation middle suggests these tests: First is direct your hand exceeding the wood. If you can tone the texture of the grain, the Quick Step Flooring Warrington has a penetrating finish (usually a immersion of a natural oil, such as linseed or tung oil, tainted like additives for drying) topped like wax. Second, in an out-of-the-way spot, dab on a little paint remover. If the finish bubbles up, it is a surface finish, like polyurethane, which coats the floor in a protective layer.
The third is in an out-of-the-way area, place a few drops of water. If the water beads happening and does not soak into the wood, the finish on the Quick Step Flooring Warrington is intact. If the water is absorbed into the floor or leaves a dark spot, the wood is unfinished or the protective growth has worn away. Fourth, if you sprinkle on a few drops of water and white bad skin form beneath the droplets after about 10 to 15 minutes, the floors are unquestionable like wax. To surgically remove the white spots, use a fragment of good steel wool lightly dampened like wax and smooth gently. The last is if you suspect a varnish or shellac, take on a coin and scrape the surface of the floor in an inconspicuous corner. If the floor has been unquestionable like one of the older execution methods, it will flake off.