To figure out whether or not your wood floors are over and done with bearing in mind a polyurethane, shellac, wax or varnish, or have a finish that has worn away and is no longer providing coverage, the American Hardwood assistance middle suggests these tests: First is direct your hand higher than the wood. If you can tone the texture of the grain, the Quick Step Laminate On Your Stairs has a penetrating finish (usually a fascination of a natural oil, such as linseed or tung oil, tainted bearing in mind additives for drying) topped bearing in mind wax. Second, in an out-of-the-way spot, dab on a little paint remover. If the finish bubbles up, it is a surface finish, bearing in mind polyurethane, which coats the floor in a protective layer.
The third is in an out-of-the-way area, place a few drops of water. If the water beads going on and does not soak into the wood, the finish on the Quick Step Laminate On Your Stairs is intact. If the water is absorbed into the floor or leaves a dark spot, the wood is unfinished or the protective deposit has worn away. Fourth, if you sprinkle on a few drops of water and white bad skin form beneath the droplets after roughly 10 to 15 minutes, the floors are sound bearing in mind wax. To remove the white spots, use a piece of fine steel wool lightly dampened bearing in mind wax and rub gently. The last is if you suspect a varnish or shellac, put up with a coin and scratch the surface of the floor in an inconspicuous corner. If the floor has been sound bearing in mind one of the older capability methods, it will flake off.