To figure out whether or not your wood floors are over and done with when a polyurethane, shellac, wax or varnish, or have a finish that has worn away and is no longer providing coverage, the American Hardwood guidance center suggests these tests: First is run your hand beyond the wood. If you can vibes the texture of the grain, the Quick Step Laminate Vs Pergo has a penetrating finish (usually a captivation of a natural oil, such as linseed or tung oil, tainted when additives for drying) topped when wax. Second, in an out-of-the-way spot, dab on a tiny paint remover. If the finish bubbles up, it is a surface finish, when polyurethane, which coats the floor in a protective layer.
The third is in an out-of-the-way area, area a few drops of water. If the water beads occurring and does not soak into the wood, the finish on the Quick Step Laminate Vs Pergo is intact. If the water is absorbed into the floor or leaves a dark spot, the wood is unfinished or the protective addition has worn away. Fourth, if you sprinkle on a few drops of water and white bad skin form beneath the droplets after more or less 10 to 15 minutes, the floors are hermetic when wax. To cut off the white spots, use a fragment of good steel wool lightly dampened when wax and rub gently. The last is if you suspect a varnish or shellac, assume a coin and scrape the surface of the floor in an inconspicuous corner. If the floor has been hermetic when one of the older expertise methods, it will flake off.