To figure out whether or not your wood floors are finished gone a polyurethane, shellac, wax or varnish, or have a finish that has worn away and is no longer providing coverage, the American Hardwood guidance center suggests these tests: First is control your hand on top of the wood. If you can vibes the texture of the grain, the Stone Floors For Living Rooms has a penetrating finish (usually a immersion of a natural oil, such as linseed or tung oil, polluted gone additives for drying) topped gone wax. Second, in an out-of-the-way spot, dab on a tiny paint remover. If the finish bubbles up, it is a surface finish, gone polyurethane, which coats the floor in a protective layer.
The third is in an out-of-the-way area, area a few drops of water. If the water beads stirring and does not soak into the wood, the finish on the Stone Floors For Living Rooms is intact. If the water is absorbed into the floor or leaves a dark spot, the wood is unfinished or the protective enlargement has worn away. Fourth, if you sprinkle on a few drops of water and white spots form beneath the droplets after about 10 to 15 minutes, the floors are hermetically sealed gone wax. To remove the white spots, use a fragment of fine steel wool lightly dampened gone wax and smear gently. The last is if you suspect a varnish or shellac, receive a coin and graze the surface of the floor in an inconspicuous corner. If the floor has been hermetically sealed gone one of the older ability methods, it will flake off.