To figure out whether or not your wood floors are ended in imitation of a polyurethane, shellac, wax or varnish, or have a finish that has worn away and is no longer providing coverage, the American Hardwood opinion center suggests these tests: First is rule your hand exceeding the wood. If you can air the texture of the grain, the Where Is Mohawk Hardwood Flooring Manufactured has a penetrating finish (usually a engagement of a natural oil, such as linseed or tung oil, infected in imitation of additives for drying) topped in imitation of wax. Second, in an out-of-the-way spot, dab upon a tiny paint remover. If the finish bubbles up, it is a surface finish, in imitation of polyurethane, which coats the floor in a protective layer.
The third is in an out-of-the-way area, place a few drops of water. If the water beads taking place and does not soak into the wood, the finish upon the Where Is Mohawk Hardwood Flooring Manufactured is intact. If the water is absorbed into the floor or leaves a dark spot, the wood is unfinished or the protective accumulation has worn away. Fourth, if you sprinkle upon a few drops of water and white spots form beneath the droplets after about 10 to 15 minutes, the floors are solid in imitation of wax. To separate the white spots, use a piece of fine steel wool lightly dampened in imitation of wax and smear gently. The last is if you suspect a varnish or shellac, bow to a coin and scuff the surface of the floor in an inconspicuous corner. If the floor has been solid in imitation of one of the older achievement methods, it will flake off.