To figure out whether or not your wood floors are ended once a polyurethane, shellac, wax or varnish, or have a finish that has worn away and is no longer providing coverage, the American Hardwood recommendation middle suggests these tests: First is run your hand higher than the wood. If you can air the texture of the grain, the Wood Flooring Company Yonkers has a penetrating finish (usually a assimilation of a natural oil, such as linseed or tung oil, unclean once additives for drying) topped once wax. Second, in an out-of-the-way spot, dab upon a tiny paint remover. If the finish bubbles up, it is a surface finish, once polyurethane, which coats the floor in a protective layer.
The third is in an out-of-the-way area, area a few drops of water. If the water beads happening and does not soak into the wood, the finish upon the Wood Flooring Company Yonkers is intact. If the water is absorbed into the floor or leaves a dark spot, the wood is unfinished or the protective mass has worn away. Fourth, if you sprinkle upon a few drops of water and white a skin condition form beneath the droplets after more or less 10 to 15 minutes, the floors are sound once wax. To separate the white spots, use a piece of fine steel wool lightly dampened once wax and smear gently. The last is if you suspect a varnish or shellac, put up with a coin and cut the surface of the floor in an inconspicuous corner. If the floor has been sound once one of the older expertise methods, it will flake off.