To figure out whether or not your wood floors are finished in the same way as a polyurethane, shellac, wax or varnish, or have a finish that has worn away and is no longer providing coverage, the American Hardwood guidance middle suggests these tests: First is rule your hand greater than the wood. If you can quality the texture of the grain, the Wooden Flooring Company In Qatar has a penetrating finish (usually a concentration of a natural oil, such as linseed or tung oil, impure in the same way as additives for drying) topped in the same way as wax. Second, in an out-of-the-way spot, dab upon a little paint remover. If the finish bubbles up, it is a surface finish, in the same way as polyurethane, which coats the floor in a protective layer.
The third is in an out-of-the-way area, place a few drops of water. If the water beads occurring and does not soak into the wood, the finish upon the Wooden Flooring Company In Qatar is intact. If the water is absorbed into the floor or leaves a dark spot, the wood is unfinished or the protective accrual has worn away. Fourth, if you sprinkle upon a few drops of water and white spots form beneath the droplets after not quite 10 to 15 minutes, the floors are strong in the same way as wax. To sever the white spots, use a fragment of fine steel wool lightly dampened in the same way as wax and daub gently. The last is if you suspect a varnish or shellac, allow a coin and scuff the surface of the floor in an inconspicuous corner. If the floor has been strong in the same way as one of the older realization methods, it will flake off.